NEC Electra Elite IPK - Synchronous Ringing Selection

Elite IPK Document Revision 1
Programming Manual 2 - 67
___________________________________________________________________________________
___________________________________________________________________________________
1-1-59 Synchronous Ringing Selection
General Description
Use this Memory Block to specify whether or not CO/PBX calls follow Synchronous
Ringing.
Display
Settings

Notes

LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
YS NO
Programming Procedures
1 Go off-line.
2
Press LK1 + LK1 +
EI
to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
4 Press
G
to write the data and display the next Memory Block.
5
Program the next Memory Block or press
E
to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-51
CO Line Ringing Pattern Selection
1-1-52
PBX Line Ringing Pattern Selection
1. Synchronous Ringing does not apply to incoming DID calls, off-hook ringing calls, or CO/PBX ring transfer calls.
2. Do not program this Memory Block if YS is assigned.
System Mode
1
Submode
1
Data No.
59
PC Programming
¦ +BCS
5 9 : S Y N C H R O N U S Y S
T I M E D I S P L A Y
Data
No.
Title
Setting
Data