NEC Electra Elite IPK - Specified Station Access Code Assignment

Electra Elite IPK Document Revision 1
Programming Manual 2 - 101
___________________________________________________________________________________
___________________________________________________________________________________
1-2-08 Specified Station Access Code
Assignment
General Description
Use this Memory Block to assign specific stations for abbreviated dialing. Up to 24
stations can be assigned.
Display
Programming Procedures
1 Go off-line.
2 Press LK1 + LK2 +
KH
to access the Memory Block.
3 Use the dial pad to enter Specified Station Access Code 00 Tel Port No.

Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
H
to clear data

Setting Data:
Tel. Port No. 01~120
Specified Station Access Code is 00~23
4 Press
G
to write data and display the next Specified Station Access Code.
5 Repeat Steps 3 and 4 for each Specified Station Access Code.
6 The next Memory Block is displayed.
7 Program the next Memory Block or press
E
to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-46
Access Code (1-Digit) Assignment
1-1-47
Access Code (2-Digit) Assignment
1-4-14
Automated Attendant Message Access Code (1-Digit) Assignment
1-4-15
Automated Attendant Message Access Code (2-Digit) Assignment
System Mode
1
Submode
2
Data No.
08
PC Programming
¦ +BA
0 8 : S P C L E X T 0 0 = 0 1
T I M E D I S P L A Y
Specified
Station
Access
Code
00~23
Data
No.
Title
Tel.Port
01~C0
Default Values
Access Code No. Value
00 01
01-23 Not Set