NEC Electra Elite IPK - LCR Class to Trunk Group Selection; Common Signaling Channel Route Assignment; Trunk Group Outgoing Priority Selection

Elite IPK Document Revision 1
Programming Manual 1 - 37
___________________________________________________________________________________
___________________________________________________________________________________
LK 5 Trunk Group Mode
Data
No.
Memory Block Name Default Value Programming Values
00 Digit Add/Del for Tie Line
Networking Assignment
000
(No Add or Delete)
Delete up to two digits
Add up to two digits
01 Tie Line Networking Tandem
Connection Assignment
All Trunk Groups
CO/PBX Line LEDs
On
On = Enable
Off = Disable
02 8-Digit Matching Table to Trunk
Group Assignment
Enabled
CO/PBX Line LEDs
On
On = Enable
Off = Disable
03 OCC Table to Trunk Group
Assignment
CO/PBX Line LEDs
On
Use All Tables
On = Enable
Off = Disable
04 LCR Class to Trunk Group
Selection
0
0~4
05 Common Signaling Channel Route
Selection
0 (Not Assigned)
CCH Range: 1~4
06 Trunk Group Outgoing Priority
Selection
H → LH → L, L → H