Elite IPK Document Revision 1
Programming Manual 2 - 35
___________________________________________________________________________________
___________________________________________________________________________________
1-1-28 Distinctive Ringing by Telephone or
CO Selection
General Description
Use this Memory Block to assign a distinctive ringing tone for each telephone or each
CO/PBX line.
Display
Settings
Notes
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
TEL CO
Programming Procedures
1 Go off-line.
2
Press LK1 +
LK1 +
BH
to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
4
Press
G
to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E
to go back on-line.
Related Programming
M.B. Number Memory Block Name
3-07
CO/PBX Ringing Variation Selection
4-01
CO/PBX Ring Assignment (Day Mode)
4-02
CO/PBX Ring Assignment (Night Mode)
4-91
Telephone Ringing Variation Selection
1. TEL = Telephone Mode
Ringing tone is specified in Memory Block 4-91 (Telephone Ringing Variation Selection).
2. CO = CO/PBX Line Mode
Ringing tone is specified for each CO/PBX line in Memory Block 3-07 (CO/PBX Ringing Variation Selection).
System Mode
1
Submode
1
Data No.
28
PC Programming
¦
+BTS
2 8 : D S T R I N G T E L
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
To Next Page
Loading...
