NEC Electra Elite IPK - Call Forward - no Answer Time Selection

Electra Elite IPK Document Revision 1
Programming Manual 2 - 109
___________________________________________________________________________________
___________________________________________________________________________________
1-2-22 Call Forward - No Answer Time
Selection
General Description
Use this Memory Block to specify the time before incoming intercom calls or incoming
CO/PBX lines are forwarded to another station number when the called party does not
answer.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
4s
8s 12s 18s 24s 30s 60s
Programming Procedures
1 Go off-line.
2 Press LK1 + LK2 +
BB
to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
4
Press
G
to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E
to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-46
Access Code (1-Digit) Assignment
1-1-47
Access Code (2-Digit) Assignment
1-1-48
Access Code (3-Digit) Assignment
1-2-01
Intercom Call Voice/Tone Signal Selection
1-8-08
Class of Service (Station) Feature Selection 2
4-17
Station to Class of Service Feature Assignment
4-42
Call Forward-Busy Immediately/Delay Selection
System Mode
1
Submode
2
Data No.
22
PC Programming
¦ +BM
2 2 : F W D N O A N S 8 s
T I M E D I S P L A Y
Setting
Data
Title
Data
No.