Elite IPK Document Revision 1
Programming Manual 2 - 275
___________________________________________________________________________________
___________________________________________________________________________________
1-13-00 PRT Channel Assignment
General Description
Use this Memory Block to assign the available B channels used for PRI.
Display
Settings
Page 1
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
Channel 1 Channel 2 Channel 3 Channel 4 Channel 5 Channel 6 Channel 7 Channel 8
Page 2
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
Channel 9 Channel 10 Channel 11 Channel 12 Channel 13 Channel 14 Channel 15 Channel 16
Page 3
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
Channel 17 Channel 18 Channel 19 Channel 20 Channel 21 Channel 22 Channel 23 Channel 24
CO/PBX
Line LED
Off
On
The shaded selection is
the default
Data
No (Not
Assigned)
Yes
(Assigned)
Programming Procedures
1 Go off-line.
2 Press LK1 + LK13 to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the Setting Data option.
4 Press
G
to write the data. The next Memory Block is displayed.
5 Program the next Memory Block or press
E
to go back on-line.
System Mode
1
Submode
13
Data No.
00
PC Programming
¦
+AN
0 1 / 0 0 : C H A N N E L | 0 1
T I M E D I S P L A Y
Data
No.
Setting
Data
PRT
1~8
Title
To Next Page
Loading...
