2 - 56 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revison 1 Elite IPK
Notes
To assign System 1 in System Programming:
1. Memory Block 1-1-46 [Access Code (1-Digit) assignment]. Assignment 2 → 401 (Closed Number Block 01).
2. Memory Block 1-1-49 (Networking Trunk Group/Route Advance Assignment). Assignment Block 01 → 102
(Trunk group 02).
3. Memory Block 1-1-50 (CO/PBX Outgoing Digit Add Assignment). Assignment Block 01 → Assign 2.
4. Digits are added when the Access Code is dialed from the internal dial tone.
5. This Memory Block also applies to ISDN trunks.
Example:
System
1
System
2
Station 100
Dials 200
Add 200
Station 200
Rings
To Next Page
Loading...
