NEC Electra Elite IPK - Page 218

Elite IPK Document Revision 1
Programming Manual 2 - 147
___________________________________________________________________________________
___________________________________________________________________________________
1-4-18 Automated Attendant Delay
Announcement Assignment
General Description
Use this Memory Block to specify the order for the Automated Attendant messages
that are played in Delayed Announcement Mode.
Display
Settings
Page 1
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
The shaded
selection is the
default.
NONE MSG1 MSG2 MSG3 MSG4 MSG5 MSG6 MSG7
Page 2
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
MSG8
Programming Procedures
1 Go off-line.
2 Press LK1 + LK4 +
JJAH
to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the 2
nd
MSG for 1
st
MSG 1.

Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data
C
to toggle between pages
Default Values
1
st
MSG No. 1~8: Not Specified
4 Press
G
to write the data and advance to the next 1
st
MSG.
5 Repeat Steps 3 and 4 for each 1
st
MSG. The next Memory Block is displayed.
6 Program the next Memory Block or press
E
to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-4-19
Automated Attendant 1
st
to 2
nd
Delay Announcement Interval Time Selection
1-4-20
Automated Attendant Delay Announcement Disconnect Time Selection
System Mode
1
Submode
4
Data No.
18
PC Programming
¦ + AU
1 8 : ( 1 ) 2 N D = N O N E | 1
T I M E D I S P L A Y
1
st
MSG
1~8
Setting
Data
2nd MSG
Data
No.
Title
Page