Elite IPK Document Revision 1
Programming Manual 2 - 163
___________________________________________________________________________________
___________________________________________________________________________________
Notes
4 Press
G
to write the data.
5 Repeat Steps 3 and 4 for all buttons for each DSS. The next Memory Block is displayed.
6 Program the next Memory Block or press
E
to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-6-01
Attendant Add-On Console to Telephone Port Assignment
7-2
Telephone Type Assignment
1. When TEL is assigned to a line key, the red LED is used to indicate Station Status.
2. When a function (e. g., Message or Paging) that does not require a green LED is assigned to a 2-color LED key,
the green LED does not function.
3. Telephone number setting data for telephone sets is determined by the number of installed ESI(8)-U( ) ETUs.
4. Message Waiting and Attendant Station Outgoing Lockout cannot be assigned on the same console.
5. DSS/CO keys should be programmed on line keys 1~48 only.
6. The Feature Access key with Live Record has seven features:
Each function can be assigned by dialing the Feature No. using the dial pad after pressing LK1 on page 3.
7. Digital Voice Mail Mailbox Number can be entered using two, three, or four digits of the Mailbox number on the
dial pad. This feature is used for Live Record addressing. The Live Record feature must be assigned to a line key
on the console also.
Programming Procedures (Continued)
Feature No. Feature
00
Record Start
01
Record Pause/Restart
02
Record Erase
03
Record Finish
04
Record Erase/Restart
05
Pager
06
Record Confirmation
07
Live Monitoring
To Next Page
Loading...
