NEC Electra Elite IPK - Page 260

Electra Elite IPK Document Revision 1
Programming Manual 2 - 189
___________________________________________________________________________________
___________________________________________________________________________________
Page 5
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
Forced
Account Code
/Authorization
Code
Group
Listening
Selection
Station
Relocation
Set Call
Forward-Off
Premise
Pre-Set
Dialing
Allow/Deny
Live
Monitoring
ANI/Caller ID
Display
Selection
Not Used
Page 6
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
ARS Overflow
VMS
Message
Indication
Unverified for
Forced
Account Code
/Authorization
Code
Not Used
Caller ID for
K-CCIS
Not Used Not Used Not Used
Programming Procedures
1 Go off-line.
2 Press LK1 + LK8 +
KH
to access the Memory Block.
3 Use the dial pad to enter Class No.

Use the following to enter Class No:
K
~
I
to enter numeric data
J
to move cursor left
L
to move the cursor right
4 Press the corresponding CO/PBX line key to allow or deny the feature selection.
The LED indication changes to indicate data each time CO/PBX line key is pressed.
Press
C
to go to the next page.
Press
A
to go back to the previous page.
5 Press
G
key to transfer data.
6 Repeat Steps 3 and 4 for each Class. The next Memory Block is displayed.
7 Program the next Memory Block or press
E
to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-8-07
Class of Service (Attendant) Feature Selection 1
4-17
Station to Class of Service Feature Assignment
CO/PBX
Line Key LED
Off On
Data Deny Allow