2 - 232 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revison 1 Elite IPK
1-9-02 DISA Password Effect/Invalid
Selection
General Description
Use this Memory Block to specify whether or not a Direct Inward System Access
(DISA) Password is required. When NO is assigned, the calling party can use the
DISA feature without a DISA Password.
This Memory Block is automatically displayed after data is written for each ID Buffer
No. (01~CO for Electra Elite 192 or 01~48 for Electra Elite 48) in Memory Block 1-9-
00. After password selection is entered, the next sequential ID Buffer NO. is displayed
on Memory Block 1-9-00. This cycle is repeated until all DISA ID codes are assigned,
and then cycles back to ID Buffer No. 1. Programming does not automatically cycle to
Memory Block 1-10-00.
Display
Settings
Related Programming
Refer to individual features in the Electra Elite IPK Features and Specifications Manual.
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
NO
YS
Programming Procedures
1 Go off-line.
2 Press LK1 + LK9 +
JB
to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
Setting Data:
NO (LK1) = DISA Password is not required.
YS (LK2) = DISA Password is required. Assign with MB 1-1-46~48 [Access Code (1-,2-, or 3-Digit) Assignment].
4 Press
G
to write the data and return to the next Memory Block 1-9-00.
5 After last DISA ID Password decision is made, press
G
to write the data and return to Buffer No. 01 on Memory Block
1-9-00.
6 Press
E
to go back on-line.
System Mode
1
Submode
9
Data No.
02
PC Programming
¦
+BD
0 1 / 0 2 : P A S W O R D = Y S
T I M E D I S P L A Y
ID Buffer
No.
(01~CO)
Title
Data
No.
Setting
Data
To Next Page
Loading...
