Elite IPK Document Revision 1
Programming Manual 2 - 253
___________________________________________________________________________________
___________________________________________________________________________________
1-10-20 Call by Call Outgoing SFG
Assignment
General Description
Use this Memory Block to specify the outgoing call service assignment for the
Simulated Facility Group (SFG).
Display
Programming Procedures
1 Go off-line.
2 Press LK1 + LK10 +
JJBK
to access the Memory Block.
3 Enter data using the dial pad.
Use the following to enter data:
J
and
L
to move the cursor
K
~
I
to enter data
D
to select next SFG No.
Setting Data = 01~64
= 99 (Not Specified)
Default Values
All SFGs 99
4 Press
G
to write the data. The next Memory Block is displayed.
5 Program Memory Blocks 1-10-21 and 1-10-22. The next SFG is displayed.
6 Repeat Steps 3, 4, and 5 for each SFG. After SFG 16 data is programmed, RAB 1 of Memory Block 1-10-00 is displayed.
7 Program the cycle again or press
E
to go back on-line.
Related Programming
M.B. Number Memory Block Name
3-03
Trunk-to-Trunk Group Assignment
1-1-30
Route Advance Block Assignment
1-1-46, 47, 48
Access Code (1-, 2-, or 3-Digit) Assignment
1-10-00
Call by Call Type of Network ID Assignment
1-10-01
Call by Call ID Plan Assignment
1-10-02
Call by Call Type of Number Assignment
System Mode
1
Submode
10
Data No.
20
PC Programming
¦
+AY
0 1 / 2 0 : O G = 9 9
T I M E D I S P L A Y
Data
No.
Setting
Data
SFG
01~16
Title
To Next Page
Loading...
