NEC Electra Elite IPK - Page 395

2 - 324 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revison 1 Electra Elite IPK
1-15-11 Centralized Billing Allow/Deny
Selection
General Description
Use this Memory Block to assign the Electra Elite IPK to send billing to the Billing
Center Office (NEAX2000/2400) across the K-CCIS network. Electra Elite IPK does
not support receiving and managing billing information.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
The shaded
selection is the
default.
Deny
NO
Allow
YS
Programming Procedures
1 Go off-line.
2
Press LK1 + LK15 +
A A
to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the Setting Data option.
4 Press
G
to write the data.
5 Press
E
to go back on-line.
Related Programming
M.B. Number Memory Block Name
7-1
Card Interface Slot Assignment
7-3-01
MIF (LCR) Assignment
7-3-02
MIF (SMDR) Assignment
1-15-00
K-CCIS Main/Remote Office Selection
1-15-01
Common Signal Channel Data Speed Assignment
1-15-02
Common Signal Channel Assignment
1-15-03
Originating Point Code Assignment
1-15-04
Destination Point Code Assignment
1-15-05
Destination Point Code Transfer Assignment
System Mode
1
Submode
15
Data No.
11
PC Programming
¦ +AW
1 1 : B I L L I N G N O
T I M E D I S P L A Y
Data
No.
Setting
Data
Title