NEC Electra Elite IPK - Page 45

1 - 14 Multiline Terminal Programming
___________________________________________________________________________________
___________________________________________________________________________________
Document Revison 1 Elite IPK
51 CO Line Ringing Pattern Selection A
A ~ H, NO
52 PBX Line Ringing Pattern Selection B
A ~ H, NO
53 Tie Line Delay Ring Pattern
Selection
D
A ~ H, NO
54 Automated Attendant Transfer Ring
Pattern
C
A ~ H, NO
55 DID Line Ringing Pattern Selection A
A ~ H, NO
57 CO/PBX Prepause Time Selection 1s
None, 1s~13s
59 Synchronous Ringing Selection YS
YS, NO
60 8-Digit Matching Table Assignment Refer to 1-1-60 8-Digit Matching Table Assignment on page
2-68.
61 8-Digit Matching Table to Class
Assignment
Refer to 1-1-61 8-Digit Matching Table to Class Assignment on
page 2-70.
62 System Speed Dial Override by
Class Selection
YS
NO = No Override
YS = Override
63 Hold Recall Time Selection
(Exclusive)
1.0
In minutes: 0.5, 1.0, 1.5, 2.0, 3.0,
5.0, 8.0,
∞
(No Limit)
64 Attendant Add-On Console
Transfer/Camp-On Recall Time
Selection
1.0
In minutes: 0.5, 1.0, 1.5, 2.0, 3.0,
5.0, 8.0, 10.0
65 Code Restriction Class Allow/Deny
Selection
Class 01 ~ 04 – YS
Class 05 ~ 14 – NO
YS (Allow)
NO (Deny)
66 8-Digit Matching Table to Normal
Dial Assignment
Tables 00 ~ 14 =
Used
(All CO/PBX Line
LEDs On)
Table 15 = Unused
(CO/PBX Line LED
Off)
N/A
67 OCC Table Assignment Tables 00 ~ 15 =
Blank
Table 16 = 1010XXX
N/A
68 8-Digit Matching Table to OCC
Table Assignment
CO/PBX Line LED
Off
Refer to 1-1-68 8-Digit Matching Table to
OCC Table Assignment on page 2-79.
LK 1 System Mode
LK 1 CO Line (Continued)
Data
No.
Memory Block Name Default Value Programming Values