NEC Electra Elite IPK - Page 467

2 - 396 Programming Manual
___________________________________________________________________________________
Document Revison 1 Elite IPK
___________________________________________________________________________________
3-18 Tie Line Release Detect Time
Selection
General Description
Use this Memory Block to specify the time before the circuit disconnect detected on
the Tie line on the distant system side is recognized as Tie line release.
Display
Settings
Page 1
LK 1 LK 2 LK 3 LK 4
LK 5 LK 6 LK 7 LK 8
The shaded
selection is the
default. Times
are in
milliseconds.
0 130 260 390
520 650 780 910
Page 2
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
1040 1170 1300 1430 1560 1690 1820 1950
Programming Procedures
1 Go off-line.
2 Press LK3 +
G
+
AH
to access the Memory Block.
3 Press the corresponding CO/PBX line key to change release detect time for CO/PBX No.

Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data or CO/PBX No.
– OR –
D
to go to the next assigned CO/PBX No.
C
to go to the next page
A
to go to the previous page
4 Press
G
to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E
to go back on-line.
CO/PBX Line Mod
e
3
Submode
—
Data No.
18
PC Programming
¦ +ALM
0 1 / 1 8 : R L S 5 2 0 | 1
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No. Title Page
Setting
Data