Elite IPK Document Revison 1
Programming Manual 2 - 427
___________________________________________________________________________________
___________________________________________________________________________________
3-44 Caller ID Display Assignment for CO/
PBX Line
General Description
Use this Memory Block to assign one Multiline Terminal to display ANI/Caller ID
Indication for incoming CO/PBX calls per CO/PBX line.
Display
Related Programming
Refer to individual features in the Electra Elite IPK Features and Specifications Manual.
Notes
Programming Procedures
1 Go off-line.
2 Press LK3 +
G
+
DD
to access the Memory Block.
3 Enter data for CO/PBX No. using the dial pad to assign ANI/Caller ID to a station.
Use the following to enter data:
J
to moves the cursor left
L
to moves the cursor right
K
~
I
to enter numeric data or CO/PBX No.
– OR –
D
to go to the next assigned CO/PBX Line No.
Enter the following:
Tel Port No. 01~CO
CO/PBX No. 01~64
Default Values
No Assignment
4 Press
G
to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E
to go back on-line.
To display ANI/Caller ID Indication for normal incoming CO calls and CAR incoming calls, both Caller ID
Indication and Ring assignment must be Programmed. A maximum of 15 Multiline Terminals can be assigned
system-wide to display ANI/Caller ID for normal incoming CO calls and CAR incoming calls using Memory Block
1-1-78 (Caller ID Display Assignment for System Mode). Another Multiline Terminal can be assigned to display
ANI/Caller ID Indication for normal incoming CO calls, per CO line, using this Memory Block.
CO/PBX Line Mod
To Next Page
Loading...
