Elite IPK Document Revison 1
Programming Manual 2 - 503
___________________________________________________________________________________
___________________________________________________________________________________
4-44 Caller ID Preset Dial Outgoing CO
Selection
General Description
Use this Memory Block to assign the Trunk group, Route Advanced group, or Closed
Numbering group that is seized for ANI/Caller ID Outgoing Calls. Use the ANI/Caller
ID Scroll key to access the ANI/Caller ID to be called.
Display
Notes
Programming Procedures
1 Go off-line.
2 Press LK4 +
DD
to access the Memory Block.
3
Use the dial pad to enter Trunk Group, Route Advance group, or Closed
Numbering group Access Code to seize for ANI/Caller ID outgoing calls for
Tel Port No.
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data or Tel Port No.
– OR –
D
to go to next assigned Tel Port No.
B
+
A
to enter A for Port Numbers 100~109
B
+
B
to enter B for Port Numbers 110~119
B
+
C
to enter C for Port Number 120
Default Value
Not specified
4 Press
G
to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E
to go back on-line.
1. Setting Data is Access Code Assignment in Memory Blocks 1-1-46, 47, 48 [Access Code (1-Digit, 2-Digit, or
3-Digit) Assignment]. For example: Dial 9 (101) → Trunk Group 1.
2. Assign the ANI/Caller ID Scroll key using Memory Blocks 2-06 (Line Key Selection for Tenant Mode) or 4-12
(Line Key Selection for Telephone Mode).
3. Telephone ports A0~C0 are ports 100~120. Use redial +1 for A, redial +2 for B, and redial +3 for C.
Telephone Mode
4
Submode
—
Data No.
44
PC Programming
¦
+AI
0 1 / 4 4 :
T I M E D I S P L A Y
Setting
Data
Data
No.
Tel
Port
No.
(01
~
C0)
To Next Page
Loading...
