NEC Electra Elite IPK - Page 588

Elite IPK Document Revison 1
Programming Manual 2 - 517
___________________________________________________________________________________
___________________________________________________________________________________
4-55 CO/PBX Telephone Ringing Pattern
Selection
General Description
Use this Memory Block to specify the ringing pattern assigned to each telephone.
Display
Settings
Page 1
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
The shaded
selection is the
default.
—
(
None)
Ringing
Pattern A
Ringing
Pattern B
Ringing
Pattern C
Ringing
Pattern D
Ringing
Pattern E
Ringing
Pattern F
Ringing
Pattern G
Page 2
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
Ringing
Pattern H
Programming Procedures
1 Go off-line.
2 Press LK4 +
EE
to access the Memory Block.
3 Press the corresponding CO/PBX line key to select the ringing pattern for Tel Port No.

Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data or Tel Port No.
– OR –
D
to go to next assigned Tel Port No.
C
to go to the next page
A
to go to the previous page
B
+
A
to enter A for Port Numbers 100~109
B
+
B
to enter B for Port Numbers 110~119
B
+
C
to enter C for Port Number 120
4
Press
G
to write the data and display the next Memory Block.
5
Program the next Memory Block or press
E
to go back on-line.
CO/PBX Line Mod
e
4
Submode
—
Data No.
55
PC Programming
¦ +BTT
0 1 / 5 5 : C O R N G – | 1
T I M E D I S P L A Y
Tel Port
No.
(01~CO)
Data
No.
Title
Setting
Data
Page