2 - 522 Memory Blocks
___________________________________________________________________________________
Document Revison 1 Elite IPK
___________________________________________________________________________________
4-58 Automated Attendant Selection for
DID
General Description
Use this Memory Block to specify the Automated Attendant message for DID calls.
Display
Settings
Page 1
Notes
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
The shaded
selection is the
default.
NON AA1 AA2 AA3 AA4 AA5 AA6 AA7
Page 2
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
AA8
Programming Procedures
1
Go off-line.
2
Press LK3 +
G
+
EH
to access the Memory Block.
3 Press the line key to specify Automated Attendant priority for Tel port No.
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data or Tel Port No.
– OR –
D
to go to next assigned Tel Port No.
C
to go to the next page
A
to go to the previous page
B
+
A
to enter A for Port Numbers 100~109
B
+
B
to enter B for Port Numbers 110~119
B
+
C
to enter C for Port Number 120
4 Press
G
to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E
to go back on-line.
Telephone Ports A0~C0 are ports 100~120.
CO/PBX Line Mod
To Next Page
Loading...
