Elite IPK Document Revision 1
Programming Manual 3 - 17
___________________________________________________________________________________
___________________________________________________________________________________
2.3.8 ARS Digit Delete Assignment (Memory Block 1-14-05)
Use this Memory Block to specify number of digits (00~10) from the
first digit that are deleted from the route assignment.
Default: 00 (None)
2.3.9 ARS Digit Add Assignment (Memory Block 1-14-06)
Use this Memory Block to specify a maximum of 10 digits to add to
the route assignment.
Default: Not Assigned
2.3.10 Trunk-to-Trunk Group Assignment (Memory Block 3-03)
Use this Memory Block to to assign a Trunk Group number to each
CO/PBX line.
Default: CO/PBX lines 01~08 in Trunk group 1
2.3.11 Trunk Type Selection (Memory Block 3-91)
Use this Memory Block to specify an external line as CO, PBX,TIE,
DID or CTX.
Default: CO
2.3.12 LCR Class Selection (Memory Block 4-40)
Use this Memory Block to specify the LCR/ARS class for each
station. The class number is the number of the Area Code Table
used. Stations cannot have multiple classes. Four area code tables
are provided. The MIFM-U( ) ETU with attached KMM(1.0)U must be
installed to support this feature.
Default: Class 0 (No LCR)
2.4 ARS Operation Example
TEL100 dials 1-9727517645, seizes trunk 8, and sends 1010288
9727517645.
1. Program the following values, if necessary:
H
1-1-46 9 (Trunk Group 1)
H
1-8-08 Page 3, LK4 (Deny)
H
1-14-00 YS
H
1-14-01 1:1972751
H
1-14-02 YS
To Next Page
Loading...
