3 - 32 Advanced Applications
___________________________________________________________________________________
___________________________________________________________________________________
Document Revison 1 Elite IPK
Call by Call Service Parameter Assignment........................ 1-10-07
Call by Call Max Digit Assignment ...................................... 1-10-08
Call by Call Simulated Facility Group Assignment .............. 1-10-09
Call by Call Outgoing SFG Assignment .............................. 1-10-20
Call by Call Outgoing/Incoming SFG Assignment............... 1-10-21
Call by Call Incoming Type Selection .................................. 1-10-22
3.3 Memory Block Description
3.3.1 DID Digit Length Selection (Memory Block 1-1-20)
Use this Memory Block to define the number of DID digits.
Default: 3
3.3.2 DID Digit Conversion Assignment (Memory Block 1-1-21)
Use this Memory Block to enable the DID Digit Conversion table.
Default: NO
3.3.3 DID Digit Conversion Table (Memory Block 1-1-22)
Use this Memory Block to assign DID numbers to ring at station
numbers, closed number (plus outgoing digits), or tenant number.
Default: Not Specified
3.3.4 DID Forward Station Number for Busy Station or Undefined Digit
(Memory Block 1-1-23)
Use this Memory Block when the DID conversion Table is enabled to
define where digits are routed when undefined or the station is busy.
Default: NON (Not Assigned)
3.3.5 Access Code (1-, 2-, or 3-Digit) Assignment (Memory Block
1-1-46~48)
Use this Memory Block to assign access codes or station numbers.
Function 080 [Outgoing (CO only) Access in same Tenant] default
Not Specified, Function 101(Trunk Group 01) default is 9, and
Function 201~232 (Route Advance Blocks 1~32) default is none
specified.
To Next Page
Loading...
