Elite IPK Document Revision 1
Programming Manual 3 - 49
___________________________________________________________________________________
___________________________________________________________________________________
H
When incoming and outgoing calls are processed simultaneously the
incoming call has priority. A collision error between simultaneous SETUP
messages is generated, and the outgoing call gets a busy signal.
H
The Incoming/outgoing (IC/OG) SFG must be equal to or greater than
the outgoing (OG) SFG. When not, In many cases, the Electra Elite
system does not accept an incoming call.
H
When Operator Call Time Out Table is set to 0 in LCR Programming, the
operator call requiring more than 1 digit cannot be used. When 0 + any
digits is stored in speed dial, the system sends the call as 0 Call
(operator) only.
To Next Page
Loading...
