Cont. 9
Saving Your Application 6-23
Restoring Saved Settings 6-24
Copying an Application 6-24
CHAPTER 7 TRIPS AND FAULT FINDING
Trips and Fault Finding ...................................................... 7-1
Trips 7-1
What Happens when a Trip Occurs 7-1
Resetting a Trip Condition 7-1
Fault Finding 7-2
Calibration Checks 7-3
Alarm Messages 7-7
Hexadecimal Representation of Trips 7-8
Power Board LED Trip Information (Frame 4, 5, 6 & H) 7-9
Using the MMI to Manage Trips 7-13
Test Points 7-19
CHAPTER 8 ROUTINE MAINTENANCE AND REPAIR
Maintenance .................................................................... 8-1
Service Procedures 8-1
Preventive Maintenance 8-1
Repair .............................................................................. 8-2
Saving Your Application Data 8-2
Returning the Unit to Parker SSD Drives 8-2
Disposal 8-3
Technical Support Checks 8-3
Repairs for Frames 4 & 5 8-5
Replacing the Fan (Frames 4 & 5) 8-5
Repairs for Frame 6 8-6
AC Fuse Replacement (Frame 6 Non-Regen Unit - 2Q) 8-6
DC Fuse Replacement (Frame 6 Regen Unit - 4Q) 8-7
Replacing a Phase Assembly (Frame 6) 8-9
Replacing a Fan (Frame 6) 8-10
Repairs for Frame H 8-11
Fuse Replacement (Frame H) 8-11
Phase Assembly Replacement (Frame H) 8-14
APPENDIX A SERIAL COMMUNICATIONS
System Port (P3) ................................................................ A-1
UDP Support A-2
System Port (P3) Set-up A-2
UDP Transfer Procedure A-2
MMI Dump Procedure A-3
DSELite Support A-4
System Port (P3) Set-up A-4
5703 Support A-5
System Port (P3) Set-up A-7
EI Bisynch ASCII Support A-8
System Port (P3) Set-up A-8
EI Binary Support A-13
System Port (P3) Set-up A-13
EI Bisynch Binary Message Protocol A-15
EI Bisynch Binary Parameter Specification Tables A-19
Error Codes A-28
ERROR REPORT (EE) A-28
APPENDIX B CERTIFICATION
Introduction ...................................................................... B-1
Europe ............................................................................. B-1
What are the European Directives? B-1
CE Marking for the Low Voltage Directive (LVD)
2006/95/EC B-2
CE Marking for the EMC Directive 2004/108/EC B-2
United States of America & Canada ..................................... B-4
Compliance B-4
Conditions for Compliance with UL508c B-4
Solid-State Motor Overload Protection B-4
Branch Circuit/Short Circuit Protection Requirements B-5
Short Circuit Rating B-6
Field Wiring Temperature Rating B-6
To Next Page
Loading...
