Parker 590+ series - Page 294

C-4 Parameter Specification Tables
DC590+ Series DC Digital Drive
Tag Mn MMI Block Name MMI Parameter Name Minimum Maximum Default Units Range Notes
60 bo CALIBRATION BACK EMF 0.0 0.0 0.0 % V0 W4
61 bp CURRENT LOOP ACTUAL NEG I LIM 0.0 0.0 0.0 % V0 W4
62 bq SPEED LOOP UNFIL.SPD.FBK 0.00 0.00 0.00 % V0 W4
63 br SPEED LOOP SPEED SETPOINT 0.00 0.00 0.00 % V0 W4
64 bs SPEED LOOP UNFIL.SPD.ERROR 0.00 0.00 0.00 % V0 W4
65 bt CURRENT LOOP IaFbk UNFILTERED 0.0 0.0 0.0 % V0 W4
66 bu CURRENT LOOP IaDmd UNFILTERED 0.0 0.0 0.0 % V0 W4
67 bv CURRENT LOOP ACTUAL POS I LIM 0.0 0.0 0.0 % V0 W4
68 bw SEQUENCING START (C3) 0 1 0
0: OFF
1: ON
V1 W4
69 bx DIGITAL INPUT 4 DIGITAL INPUT C4 0 1 0
0: OFF
1: ON
V1 W4
70 by DIGITAL INPUT 5 DIGITAL INPUT C5 0 1 0
0: OFF
1: ON
V1 W4
71 bz DIGITAL INPUT 1 DIGIN 1 (C6) 0 1 0
0: OFF
1: ON
V1 W4
72 c0 DIGITAL INPUT 2 DIGIN 2 (C7) 0 1 0
0: OFF
1: ON
V1 W4
73 c1 DIGITAL INPUT 3 DIGIN 3 (C8) 0 1 0
0: OFF
1: ON
V1 W4
74 c2 DIGITAL OUTPUT 1 DIGOUT 1 (B5) 0 1 0
0: OFF
1: ON
V1 W4
75 c3 DIGITAL OUTPUT 2 DIGOUT 2 (B6) 0 1 0
0: OFF
1: ON
V1 W4
76 c4 DIGITAL OUTPUT 3 DIGOUT 3 (B7) 0 1 0
0: OFF
1: ON
V1 W4
77 c5 STANDSTILL AT ZERO SPEED 0 1 0 V0 W4
78 c6 STANDSTILL AT ZERO SETPOINT 0 1 0 V1 W4
79 c7 STANDSTILL AT STANDSTILL 0 1 0 V1 W4
80 c8 SEQUENCING PROGRAM STOP 0 1 0 V1 W4
81 c9 ALARMS SPEED FBK ALARM 0 1 0
0: ENABLED
1: INHIBITED
V0 W0
82 ca SEQUENCING DRIVE START 0 1 0
0: OFF
1: ON
V0 W4
83 cb SEQUENCING CONTACTOR CLOSED 0 1 0 V0 W4