Parker AC30 series - Page 116

8-32 Ethernet
AC30 series Variable Speed Inverters
Sets the UDP port number the Peer to Peer module receives the data on. Normally this will be set the
same as the Destination Port.
Peer to Peer State
172
9
Monitor::Communications::Pe
er to Peer Parameters::Base
Comms::Peer to Peer
DISABLED DISABLED
ACTIVE
ERROR
NEVER
Peer to Peer Parameter.
A diagnostic parameter indicating the state of the Peer to Peer module.
Enumerated values:
0: DISABLED - the Peer to Peer module is disabled.
1: ACTIVE - the Peer to Peer module is enabled and ready for communications.
2: ERROR
- the Peer to Peer module is in an error state and communications could not be established.