Parker AC30 series User Manual

C-34 Parameter Reference
AC30 series Variable Speed Drive
Parameter Name
No.
Path
Default
Range
Units
Writable
Notes:
1) The clone file only contains the parameters that were stored in non-volatile memory on the drive when a clone save was
performed. When performing a clone load and a full restore is performed or a LOAD FROM FILE is used for the parameters,
then any parameter not previously saved in the file will be set to its defaults.
2) Each application parameter is restored only if the parameter definition on the target drive matches the saved parameter.
3) The clone saving process will take between 3 – 15 seconds depending on the type of SD card used.
4) When saving a file with the same filename as an existing file on the SD card, the existing file will be overwritten. To prevent
this, use a PC to set the read-only attribute of the file.
5) During the clone loading process the GKP screen may blank momentarily.

Parker AC30 series Specifications

General

Control Modes	Closed-loop vector
Feedback	Encoder
Operating Temperature	0 to 40°C (32 to 104°F) standard, -20 to 50°C (-4 to 122°F) with derating
Protection	Overcurrent, Overvoltage, Undervoltage
Communication	RS485