Parker AC30 series - Page 345

Parameter Reference C-163
AC30 series Variable Speed Drive
Parameter Name
No.
Path
Default
Range
Units
Writable
Ramp Speed Output
0500
Parameters::Motor Control::Ramp
x.x -200.0 to 200.0 %
NEVER
Output speed
Jog Setpoint
0501
Parameters::Motor Control::Ramp
10.0 0.0 to 100.0 %
ALWAYS
The setpoint is the target reference that the Drive will ramp to
Jog Acceleration Time
0502
Parameters::Motor Control::Ramp
1.000 0.000 to 3000.000 s
ALWAYS
The time that the Drive will take to ramp the jog setpoint from 0.00% to 100.00%.
Jog Deceleration Time
0503
Parameters::Motor Control::Ramp
1.000 0.000 to 3000.000 s
ALWAYS
The time that the Drive will take to ramp the jog setpoint from 100.00% to 0.00%.
Stop Ramp Time
0504
Same as PNO 484
10.000 0.000 to 600.000 s
ALWAYS
Rate at which the demand is ramped to zero after the ramp has been quenched
Zero Speed Threshold
0505
Parameters::Motor Control::Ramp
0.1 0.0 to 100.0 %
ALWAYS
Hold for zero speed detection used by stop sequences
Zero Speed Stop Delay
0506
Parameters::Motor Control::Ramp
0.500 0.000 to 30.000 s
ALWAYS
Sets the time at which the Drive holds zero speed before quenching after a normal stop or a jog stop. This may be particularly useful if
a mechanical brake requires time to operate at zero speed, or for jogging a machine to position