C-224 Parameter Reference
AC30 series Variable Speed Drive
An enumerated value that shows the trip that caused the AC30 to disable the stack. When multiple trips are active at the same time,
(for example Over Current followed by Over Temperature), this parameters shows the first trip that the AC30 detected. Refer to
Chapter 10 “Trips and Fault Finding”, for details of each trip source.
Enable 1 - 32
0697
Parameters::Trips::Trips Status
FFFFFF7F
5:06 CURRENT LIMIT
6:07 MOTOR STALL
7:08 INVERSE TIME
8:09 MOTOR I2T
9:10 LOW SPEED I
11:12 INTERNAL OVERTEMP
12:13 MOTOR OVERTEMP
13:14 EXTERNAL TRIP
14:15 BRAKE SHORT CCT
15:16 BRAKE RESISTOR
16:17 BRAKE SWITCH
17:18 LOCAL CONTROL
18:19 COMMS BREAK
19:20 LINE CONTACTOR
20:21 PHASE FAIL
21:22 VDC RIPPLE
22:23 BASE MODBUS BREAK
23:24 24 V OVERLOAD
24:25 PMAC SPEED ERROR
25:26 OVERSPEED
28:29 INTERNAL FAN FAIL
29:30 CURRENT SENSOR
30:31 POWER LOSS STOP
31:32 SPEED SENSOR
ALWAYS
A 32-bit word that can be used to enable, (or disable), individual trips. Refer to Chapter 10 “Trips and Fault Finding” for details of the
value corresponding to each trip.
To Next Page
Loading...
