Parker AC30 series User Manual

6-17 Setup Wizard
AC30 series Variable Speed Inverter
All the Wizard Tasks use a similar sequence of pages to find and program a Drive. The following page shows the Setup a New Drive wizard and
the Find a Drive page
Figure 9-5 Automatic Drive detection
The wizard will automatically detect all the inverters that are visible to the PC via it’s Ethernet connections. This normally takes 10 seconds,
during which time the user interface will go grey and will not respond to you. Once the inverter detection is complete, find your inverter in the list
and click on it with the mouse. Information about the selected Drive will be displayed in the status area at the bottom of the screen. Ensure you
have selected the correct Drive before continuing. If Drive Brake Switch is not fitted it will be indicted by the symbol as shown in Figure 9-5.

Parker AC30 series Specifications

General

Control Modes	Closed-loop vector
Feedback	Encoder
Operating Temperature	0 to 40°C (32 to 104°F) standard, -20 to 50°C (-4 to 122°F) with derating
Protection	Overcurrent, Overvoltage, Undervoltage
Communication	RS485