R&S ZNL Series - Page 1048

Command reference
R&S
®
ZNL/ZNLE
1048User Manual 1178.5966.02 ─ 20
Example:
SOUR:POW3:CORR:COLL BSEN
Perform a source power calibration for port 3 using power meter
no. 2.
SOUR:POW:CORR:PMET:ID 2
Select power meter no. 2.
SOUR:POW:CORR:ACQ PORT,3
Perform a source power calibration for port 3 using the previ-
ously selected power meter no. 2.
Usage: Setting only
Manual operation: See "Start Cal Sweep" on page 491
TRACe:CLEar <MemTrace>
Deletes one of the memory traces Mem<n>[Trc<m>], where n = 1, ... 8.
Setting parameters:
<MemTrace> MDATa1 | MDATa2 | MDATa3 | MDATa4 | MDATa5 | MDATa6 |
MDATa7 | MDATa8
Identifier for the memory trace; see Table 11-20.
Range: MDATA<n> where <n> = 1 to 8.
Example:
SWE:POIN 20
Create a trace with 20 sweep points, making the created trace
the active trace of channel 1 (omitted optional mnemonic
SENSe1).
TRAC:COPY "Mem_Pt20",CH1DATA
Copy the current state of the created trace to a memory trace
named "Mem_Pt20". The memory trace is not displayed.
DISP:WIND:TRAC2:FEED "MEM_PT20"
Display the created memory trace in the active diagram area
(diagram area no. 1).
Usage: Setting only
TRACe[:DATA][:RESPonse][:ALL]? <Response>
Returns the response values of the active data trace or memory trace (see
Table 11-20).
Note: To read the response values of an arbitrary data or memory trace, use
CALCulate<Chn>:DATA. To read the response values of a trace acquired in single
sweep mode (INITiate<Ch>:CONTinuous OFF), use CALCulate<Chn>:DATA:
NSWeep:FIRSt?.
VNA command reference