VNA GUI reference
R&S
®
ZNL/ZNLE
491User Manual 1178.5966.02 ─ 20
Start Cal Sweep
Starts the calibration sweeps for the selected port and power calibration settings and
closes the dialog. The calibration is performed as described in "Calibration procedure"
on page 273.
Open the Power Cal Settings tab if you wish to modify the calibration procedure.
Remote command:
SOURce<Ch>:POWer:CORRection[:ACQuire]
SOURce<Ch>:POWer<PhyPt>:CORRection:COLLect[:ACQuire]
Calibrate Only Port Frequency
Ignored. Not relevant for the R&S ZNL.
Power Cal dialog – Meas. Receiver
In "Meas. Receiver" mode, the "Power Cal" dialog guides you through the calibration of
a measurement receiver. To ensure accurate source signal powers, a source power
calibration must be performed before the measurement receiver calibration.
Background information
Refer to Chapter 9.5.6.2, "Measurement receiver calibration", on page 274.
Access: Power Cal wizard > "Meas. Receiver"
Cal softtool
To Next Page
Loading...
