To Next Page

To Previous Page

Command reference

R&S

ZNL/ZNLE

718User Manual 1178.5966.02 ─ 20

CALCulate:RIPPle...

The CALCulate:RIPPle... commands define the ripple limits and control the ripple

limit check.

CALCulate<Chn>:RIPPle:CLEar......................................................................................718

CALCulate<Chn>:RIPPle:CONTrol:DOMain......................................................................718

CALCulate<Chn>:RIPPle:DATA.......................................................................................719

CALCulate<Chn>:RIPPle:DELete:ALL..............................................................................720

CALCulate:RIPPle:DISPlay:RESult:ALL[:STATe]............................................................... 720

CALCulate<Chn>:RIPPle:DISPlay[:STATe]....................................................................... 721

CALCulate<Chn>:RIPPle:FAIL?.......................................................................................721

CALCulate:RIPPle:FAIL:ALL?..........................................................................................721

CALCulate<Chn>:RIPPle:RDOMain:FORMat....................................................................722

CALCulate<Chn>:RIPPle:SEGMent:COUNt?....................................................................722

CALCulate<Chn>:RIPPle:SEGMent<Seg>:LIMit............................................................... 723

CALCulate<Chn>:RIPPle:SEGMent<Seg>:RESult?...........................................................723

CALCulate<Chn>:RIPPle:SEGMent<Seg>[:STATe]........................................................... 724

CALCulate<Chn>:RIPPle:SEGMent<Seg>:STIMulus:STARt...............................................724

CALCulate<Chn>:RIPPle:SEGMent<Seg>:STIMulus:STOP............................................... 724

CALCulate<Chn>:RIPPle:SOUNd[:STATe]........................................................................725

CALCulate<Chn>:RIPPle:STATe......................................................................................725

CALCulate<Chn>:RIPPle:STATe:AREA............................................................................ 726

CALCulate<Chn>:RIPPle:CLEar

Resets the limit check results for the ripple test.

Suffix:

<Chn>

Channel number used to identify the active trace

Usage: Event

Manual operation: See "Clear Test" on page 442

CALCulate<Chn>:RIPPle:CONTrol:DOMain <SweepType>

Deletes the existing ripple limit ranges and (re-)defines the physical units of the stimu-

lus values of the ripple limit lines. The unit of the ripple limit is defined via

CALCulate<Chn>:RIPPle:RDOMain:FORMat.

Suffix:

<Chn>

Channel number used to identify the active trace

VNA command reference

R&S ZNL Series User Manual

Other manuals for R&S ZNL Series