R&S ZNL Series - Page 806

Command reference
R&S
®
ZNL/ZNLE
806User Manual 1178.5966.02 ─ 20
ON
Create channel no. <Ch> and/or sets it as the active channel.
CONFigure:CHANnel<Ch> ON creates channels without
traces, so that no measurement can be initiated. Use
CALCulate<Ch>:PARameter:SDEFine
<TraceName>, <Result> to create traces or a channel and a
trace in one go.
Use CONFigure:CHANnel<Ch>:NAME to define the channel
name.
OFF
Deletes channel no. <Ch>, if it exists. Otherwise an error is
returned.
In contrast to manual control, where one channel and trace
always remains, in remote control it is possible to remove all
channels.
*RST:
ON for channel no. 1 (created on *RST), OFF for all
other channels.
Example: See CONFigure:CHANnel:CATalog?
Manual operation: See "New Channel" on page 526
CONFigure:CHANnel<Ch>:TRACe:CATalog?
Returns the numbers and names of all traces in channel no. <Ch>. The response is a
string containing a comma-separated list of trace numbers and names; see example. If
all traces have been deleted the response is an empty string ("").
Tip: Use CONFigure:TRACe:CATalog? to query the traces in all channels of the
active channel setup.
Suffix:
<Ch>
.
Channel number
Example: See CONFigure:TRACe:CATalog?
Usage: Query only
Manual operation: See "Table Area" on page 349
CONFigure:CHANnel<Ch>:TRACe:REName <TraceName>
Assigns a (new) name to the active trace in channel <Ch>.
Suffix:
<Ch>
.
Channel number
Setting parameters:
<TraceName> Trace name, e.g. 'Trace 4'.
VNA command reference