Command reference
R&S
®
ZNL/ZNLE
802User Manual 1178.5966.02 ─ 20
CALCulate:TDVSwr[:STATe] <Boolean>
Enables/disables time domain site VSWR measurements.
Parameters:
<Boolean> ON | OFF – TD-VSWR on or off.
*RST: OFF
11.5.2.2 CONFigure commands
The CONFigure... commands create and delete channels or traces, assign channel
and trace names, and define the channel sweep order. The commands are device-spe-
cific.
CONFigure:CHANnel:CATalog?.......................................................................................802
CONFigure:CHANnel:MEASure:ACTive[:STATe]............................................................... 803
CONFigure:CHANnel:MEASure:ALL[:STATe].................................................................... 803
CONFigure:CHANnel:MEASure:OPTimized......................................................................803
CONFigure:CHANnel<Ch>:MEASure[:STATe]...................................................................804
CONFigure:CHANnel<Ch>:NAME................................................................................... 805
CONFigure:CHANnel<Ch>:NAME:ID?............................................................................. 805
CONFigure:CHANnel<Ch>[:STATe]..................................................................................805
CONFigure:CHANnel<Ch>:TRACe:CATalog?................................................................... 806
CONFigure:CHANnel<Ch>:TRACe:REName....................................................................806
CONFigure:TRACe:CATalog?..........................................................................................807
CONFigure:TRACe<Trc>:CHANnel:NAME?......................................................................807
CONFigure:TRACe<Trc>:CHANnel:NAME:ID?................................................................. 808
CONFigure:TRACe<Trc>:NAME......................................................................................808
CONFigure:TRACe<Trc>:NAME:ID?................................................................................808
CONFigure:TRACe<Trc>:REName..................................................................................809
CONFigure:TRACe:WINDow?.........................................................................................809
CONFigure:TRACe:WINDow:TRACe?............................................................................. 809
CONFigure:CHANnel:CATalog?
Returns the numbers and names of all channels in the current channel setup. The
response is a string containing a comma-separated list of channel numbers and
names; see example below. If all channels have been deleted the response is an
empty string ("").
Example:
*RST; :CONF:CHAN2:STAT ON; NAME 'New Channel'
Create channel 2 and assign the channel name "New Channel".
CONF:CHAN:CAT?
Query all channels and their names. As a default channel no. 1
is created on *RST, the response is
'1,Ch1,2,New_Channel'.
CONF:CHAN:NAME:ID? 'New Channel'
Query the channel number for the channel named "New Chan-
nel". The response is 2.
Usage: Query only
VNA command reference
To Next Page
Loading...
Need help?
General
