R&S ZNL Series - Page 837

Command reference
R&S
®
ZNL/ZNLE
837User Manual 1178.5966.02 ─ 20
HCOPy:PAGE:MARGin:BOTTom <LowMargin>
Defines the distance between the bottom of the page and the bottom of the printed
information.
Parameters:
<LowMargin> Lower margin
Range: 0.01 mm to 10000 mm
*RST: n/a (*RST does not affect the printer configuration)
Example:
HCOP:PAGE:MARG:BOTT 10; TOP 10
Set an upper and a lower margin of 1 cm.
HCOPy:PAGE:MARGin:LEFT
<LeftMargin>
Defines the distance between the left edge of the page and the left edge of the printed
information.
Parameters:
<LeftMargin> Left margin
Range: 0.01 mm to 10000 mm
*RST: n/a (*RST does not affect the printer configuration)
Example:
HCOP:PAGE:MARG:LEFT 10; RIGHT 10
Set an left and a right margin of 1 cm.
HCOPy:PAGE:MARGin:RIGHt <RightMargin>
Defines the distance between the right edge of the page and the right edge of the prin-
ted information.
Parameters:
<RightMargin> Right margin
Range: 0.01 mm to 10000 mm
*RST: n/a (*RST does not affect the printer configuration)
Example:
HCOP:PAGE:MARG:LEFT 10; RIGHT 10
Set an left and a right margin of 1 cm.
HCOPy:PAGE:MARGin:TOP <UppMargin>
Defines the distance between the top of the page and the top of the printed informa-
tion.
Parameters:
<UppMargin> Upper margin
Range: 0.01 mm to 10000 mm
*RST: n/a (*RST does not affect the printer configuration)
Example:
HCOP:PAGE:MARG:BOTT 10; TOP 10
Set an upper and a lower margin of 1 cm.
VNA command reference