R&S ZNL Series - Page 981

Command reference
R&S
®
ZNL/ZNLE
981User Manual 1178.5966.02 ─ 20
SOURce:POWer:CORRection:TCOefficient:DELete:ALL [<DeEmbedding Position>]
Clears the transmission coefficient list.
Parameters:
<DeEmbedding
Position>
BOTH | DUT | PM
Determines the two-port the command refers to:
DUT
The two-port between VNA and DUT (during measurement)
PM
The two-port between VNA and PM (during power calibration)
BOTH
Both positions
(parameter omitted)
If the parameter is omitted, the command refers to the two-port
selected using SOURce<Ch>:POWer<PhyPt>:CORRection:
TCOefficient:CALibration.
Example:
See SOURce:POWer:CORRection:TCOefficient[:STATe]
on page 983
Usage: Setting only
Manual operation: See "Frequency / Transm. Coefficients: Insert, Delete, Delete
All" on page 515
SOURce:POWer:CORRection:TCOefficient:DELete<ListNo>[:DUMMy]
[<DeEmbedding Position>]
Deletes entry <ListNo> from the transmission coefficient list.
Suffix:
<Ch>
.
Calibrated channel number. This suffix is ignored; the transmis-
sion coefficient settings are valid for all channels.
<PhyPt> Calibrated port number. This suffix is ignored; the transmission
coefficient settings are valid for all sources.
<ListNo> List entry no.
Parameters:
<DeEmbedding
Position>
BOTH | DUT | PM
Determines the two-port the command refers to:
DUT
The two-port between VNA and DUT (during measurement)
PM
The two-port between VNA and PM (during power calibration)
BOTH
Both positions
VNA command reference