R&S ZVB - Page 1014

R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT Command Reference
SCPI Command Reference
Operating Manual 1145.1084.12 – 30 999
SOURce<Ch>:POWer<Pt>:PERManent[:STATe] <Boolean>
Defines whether the source power is permanently on.
<Ch>
Channel number.
<Pt>
Test port number of the analyzer.
<Boolean>
ON - Power at port <Pt> is permanently on
OFF - Power is only on for the partial measurements that require the port as
a drive port.
*RST value
OFF
SCPI, Command
Types
Device-specific, command or query
Example:
SOUR:POW2:STAT ON
Switch the RF power at port no. 2 on.
SOUR:POW2:PERM ON
Activate a permanent signal source.
SOURce<Ch>:POWer<Pt>:REDuce <Boolean>
Defines whether the power at the NWA ports shall be reduced at sweep end.
[Exception: single channel with a single driving port, performing a Time or CW Mode sweep
(SENSe<Ch>:SWEep:TYPE CW | POINt)]
<Ch>
Channel number.
This suffix is ignored because the setting applies to all channels.
<Pt>
Test port number of the analyzer.
This suffix is ignored because the setting applies to all source ports.
<Boolean>
ON – Power shall be reduced at sweep end.
OFF – Power shall be not be reduced at sweep end.
*RST value
– (a reset leaves the setting unchanged)
SCPI, Command Types
Device-specific, command or query
Example:
SOUR:POW:RED ON
Reduce power at sweep end.
SOURce<Ch>:POWer<Pt>:STARt <numeric_value>
Defines the start power for a power sweep which is equal to the left edge of a Cartesian diagram. A power
sweep must be active ([SENSe<Ch>:]SWEep:TYPE POWer) before this command can be used.
<Ch>
Channel number.