R&S ZVB - Page 1051

R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT Command Reference
SCPI Command Reference
Operating Manual 1145.1084.12 – 30 1036
Replace the previous 3 points by the trace points of the default trace 'Trc1'.
MMEM:STOR:CORR:TCO 'C:\Program Files\Rohde&Schwarz\Network
Analyzer\PowermeterCorrLists\Test.pmcl'
Store the power loss list to the power meter correction list file Test.pmcl in the
directory C:\Program Files\Rohde&Schwarz\Network
Analyzer\PowermeterCorrLists.
MMEM:LOAD:CORR:TCO 'C:\Program Files\Rohde&Schwarz\Network
Analyzer\PowermeterCorrLists\Test.pmcl'
Re-load the stored power meter correction list file.
SOUR:POW:CORR:TCO:DEL1
Delete the first point in the list.
SOUR:POW:CORR:TCO:DEL:ALL; :SOUR:POW:CORR:TCO?
Clear the entire list. Query whether the transmission coefficients are still taken into
account. The response is 0.
MMEM:LOAD:CORR:TCO 'C:\Program Files\Rohde&Schwarz\Network Analyzer\Traces\Test.s2p', 'S21'
Load a power loss list from a previously created 2-port Touchstone file.
SOURce<Ch>:POWer<Pt>:CORRection:TCOefficient:COUNt?
Queries the number of frequency values and transmission coefficients in the power loss list.
<Ch>
Calibrated channel number. This parameter is ignored; the transmission
coefficient settings are valid for all channels.
<Pt>
Calibrated port number. This parameter is ignored; the transmission coefficient
settings are valid for all sources.
SCPI,
Command
Types
Device-specific, query only
Example:
See SOURce<Ch>:POWer<Pt>:CORRection:TCOefficient:CALibration
SOURce<Ch>:POWer<Pt>:CORRection:TCOefficient:DEFine<List_No>
<frequency>, <transmission>
Adds a new frequency and transmission coefficient to the end of the power loss list.
<Ch>
Calibrated channel number. This parameter is ignored; the transmission
coefficient settings are valid for all channels.
<Pt>
Calibrated port number. This parameter is ignored; the transmission coefficient
settings are valid for all sources.
<List_no>
Number of point in the list. This suffix is only used for queries.
<frequency>
Stimulus frequency value
Range [def. unit]
Stimulus values outside the frequency range of the analyzer are allowed [Hz]. If
several points with identical frequencies are added, the analyzer automatically