R&S ZVB - Page 789

R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT Command Reference
SCPI Command Reference
Operating Manual 1145.1084.12 – 30 774
is FRTR0104.
CORR:COLL:SAVE:SEL:DEF; :MMEM:STOR:CORR 1, 'P1-P4.cal'
Create a default calibration data set for the selected
calibration and store the data to a cal group file.
MMEM:LOAD:CORR:MERGE 1, 'P1-P3.cal', 'P1-P4.cal';
:CORR:COLL:METH:DEF?
Load and merge the two cal group files and query the active
calibrations again. The response is FRTR0103,FRTR0104.
MMEM:STOR:CORR 1, 'Merged.cal'
Store both calibrations to a common cal group file.
MMEMory:LOAD:CORRection:RESolve <channel> | ALL [,'<file_name>']
Resolves the pool link between channel <Ch> and a correction data set (cal group file). After resolving the
pool link, the analyzer keeps the previous system error correction as a channel calibration (Channel Cal).
A new calibration will replace the channel calibration but not overwrite the old cal group file (and not affect
other channels).
<channel> |
ALL
Channel number of an existing channel. ALL resolves the pool link for all channels.
'<file_name>'
Optional string parameter to specify the name of the cal group file. Cal group files
must have the extension *.cal. The directory must not be specified; the analyzer
always uses the default path C:\Program Files\Rohde&Schwarz\Network
Analyzer\Calibration\Data.
If there is no link between <Ch> and the specified file, the command has no effect.
If no file is specified, the command resolves any link between <Ch> and an
arbitrary cal group file.
*RST value
–
SCPI,
Command
Types
Device-specific, no query.
Example:
See MMEMory:LOAD:CORRection
MMEMory:LOAD:CORRection:TCOefficient '<file name>'[,'<parameter name/trace
name>']
Loads trace data from a specified power meter correction file or trace file and assigns it to a trace with a
specified name. Traces are created using the CALCulate<Ch>:PARameter:SDEFine... command.
Renormalization rules for imported Touchstone files
In automatic renormalization mode (MMEMory:SETTings:RENorm:MODE AUTO), renormalization is
enabled. In explicit renormalization mode (MMEMory:SETTings:RENorm:MODE EXPLicit),
renormalization is controlled by MMEMory:SETTings:RENorm:STATe.
The analyzer uses the connector impedance of the physical ports as a target impedance; the