R&S ZVB - Page 989

R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT Command Reference
SCPI Command Reference
Operating Manual 1145.1084.12 – 30 974
<Ch>
Channel number. If unspecified the numeric suffix is set to 1.
<Pt>
Test port number of the analyzer.
<Boolean>
Signal is coherent (ON) or non-coherent (OFF).
*RST value
OFF
SCPI, Command Types
Device-specific, command or query
Example:
See SOURce<Ch>:CMODe:PORT<Pt>:AMPlitude
SOURce<Ch>:CMODe:RPORt <port no.>
Selects the reference port for the Defined Coherence Mode.
<Ch>
Channel number. If unspecified the numeric suffix is set to 1.
<port no.>
Test port number of the analyzer.
Range [def. unit]
1 to the total number of ports of the analyzer (must be > 2)
*RST value
1
SCPI, Command Types
Device-specific, command or query
Example:
See SOURce<Ch>:CMODe:PORT<Pt>:AMPlitude
SOURce<Ch>:CMODe:TOLerance:AMPLitude <Tolerance>
Defines the amplitude tolerance for the Defined Coherence Mode (and the True Differential Mode; see
also SOURce<Ch>:TDIF:TOLerance:AMPlitude).
<Ch>
Channel number. If unspecified the numeric suffix is set to 1.
<Tolerance>
Amplitude tolerance
Range [def. unit]
0.01 dB to 1 dB
*RST value
0.1 dB
SCPI, Command Types
Device-specific, command or query
Example:
*RST; SOURce1:CMODe:TOLerance:AMPlitude 0.01 DB
SOURce<Ch>:CMODe:TOLerance:PHASe 0.1 DEG
Sets the tolerances to their minimum possible values
SOURce<Ch>:CMODe:TOLerance:PHASe <Tolerance>
Defines the phase tolerance for the Defined Coherence Mode (and the True Differential Mode; see also
SOURce<Ch>:TDIF:TOLerance:PHASe).
<Ch>
Channel number. If unspecified the numeric suffix is set to 1.
<Tolerance>
Phase tolerance