Rohde & Schwarz FSVA - Page 312

Instrument Functions
R&S
®
FSVA/FSV
312Operating Manual 1176.7510.02 ─ 09
OBW (span > 0)
Activates measurement of the occupied bandwidth according to the current configura-
tion and opens a submenu to configure the measurement. For details see Chap-
ter 3.3.5.4, "Measuring the Occupied Bandwidth", on page 340.
Remote command:
CALCulate<n>:MARKer<m>:FUNCtion:POWer:SELect on page 703
CALCulate<n>:MARKer<m>:FUNCtion:POWer:RESult? on page 700
CALCulate<n>:MARKer<m>:FUNCtion:POWer[:STATe] on page 704
Spectrum Emission Mask
Opens a submenu to configure the Spectrum Emission Mask measurement.
The Spectrum Emission Mask (SEM) measurement defines a measurement that moni-
tors compliance with a spectral mask.
For details see Chapter 3.3.5.5, "Measuring with Spectrum Emission Masks",
on page 344.
Remote command:
SENS:SWE:MODE ESP, see [SENSe:]SWEep:MODE on page 857
Spurious Emissions
Opens a submenu to configure the Spurious Emissions measurement.
The Spurious Emissions measurement defines a measurement that monitors unwan-
ted RF products outside the assigned frequency band generated by an amplifier.
For details see Chapter 3.3.5.6, "Measuring Spurious Emissions", on page 372.
Remote command:
SENS:SWE:MODE LIST, see [SENSe:]SWEep:MODE on page 857
Time Domain Power (zero span)
Activates the power measurement in zero span and opens a submenu to configure the
power measurement. For details see Chapter 3.3.5.7, "Measuring the Power in Zero
Span", on page 383.
Remote command:
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary[:STATe] on page 727
All Functions Off
Switches off all power measurement functions.
APD
Activates the function to measure the amplitude probability density (APD) and opens a
submenu.
For details see Chapter 3.3.5.8, "Calculating Signal Amplitude Statistics",
on page 386.
Remote command:
CALCulate<n>:STATistics:APD[:STATe] on page 737
Measurement Functions