Remote Control
R&S
®
FSVA/FSV
679Operating Manual 1176.7510.02 ─ 09
Suffix:
<n>
.
irrelevant
<m> irrelevant
Return values:
<Power> Signal power over the marker bandwidth.
Example: Activate the band power marker:
CALC:MARK:FUNC:BPOW:STAT ON
Select the density mode for the result:
CALC:MARK:FUNC:BPOW:MODE DENS
Query the result:
CALC:MARK:FUNC:BPOW:RES?
Response:
20dBm/Hz
Usage: Query only
Manual operation: See "Power" on page 295
See "Density" on page 295
CALCulate<n>:MARKer<m>:FUNCtion:BPOWer:SPAN <Span>
This command defines the bandwidth around the marker position.
Suffix:
<n>
.
irrelevant
<m> irrelevant
Parameters:
<Span> Numeric value that defines the span in Hz.
The maximum span depends on the marker position and
R&S FSVA/FSV model.
*RST: 5% of current span
Example:
CALC:MARK:FUNC:BPOW:SPAN 20
Manual operation: See "Span" on page 295
CALCulate<n>:MARKer<m>:FUNCtion:BPOWer[:STATe] <State>
This command turns markers for band power measurements on and off.
If necessary, the command also turns on a marker. If a marker is already on, the cur-
rently active marker is used as the band power marker (all other marker functions for
this marker are deactivated).
For details see Chapter 3.3.3.8, "Performing Band Power Measurements",
on page 299.
Suffix:
<n>
.
irrelevant
<m> irrelevant
Remote Control – Commands
To Next Page
Loading...
