Rohde & Schwarz FSVA - Page 892

Remote Control
R&S
®
FSVA/FSV
892Operating Manual 1176.7510.02 ─ 09
TRACe<n>:IQ:BWIDth....................................................................................................893
TRACe<n>:IQ:DATA...................................................................................................... 894
TRACe<n>:IQ:DATA:FORMat.........................................................................................894
TRACe<n>:IQ:DATA:MEMory?....................................................................................... 896
TRACe<n>:IQ:DIQFilter..................................................................................................897
TRACe<n>:IQ:EGATe.................................................................................................... 898
TRACe<n>:IQ:EGATe:GAP............................................................................................ 898
TRACe<n>:IQ:EGATe:LENGth........................................................................................898
TRACe<n>:IQ:EGATe:NOFgateperiods............................................................................899
TRACe<n>:IQ:EGATe:TYPE...........................................................................................899
TRACe<n>:IQ:EVAL.......................................................................................................899
TRACe<n>:IQ:RLENgth..................................................................................................900
TRACe<n>:IQ:SET.........................................................................................................901
TRACe<n>:IQ:SRATe.................................................................................................... 903
TRACe<n>:IQ:TPISample?.............................................................................................903
TRACe:IQ:WBANd[:STATe]............................................................................................ 903
TRACe<n>:IQ[:STATe] <State>
This command switches the I/Q data acquisition on or off.
I/Q data acquisition is not compatible with other measurement functions. Therefore, all
other measurement functions are switched off as soon as the I/Q measurement func-
tion is switched on. The trace display is also switched off by this command. Therefore,
all traces are set to "BLANK".
To switch trace display back on, use the TRACe<n>:IQ:EVAL command.
Note: to enable the evaluation functions of the IQ Analyzer, you must also execute the
command TRACe<n>:IQ:EVAL.
Suffix:
<n>
.
irrelevant
Parameters:
<State> ON | OFF
*RST: OFF
Example:
TRAC:IQ ON
Switches on I/Q data acquisition
Manual operation: See "I/Q Analyzer" on page 442
TRACe<n>:IQ:AVERage:COUNt <NumberSets>
This command defines the number of I/Q data sets that are to serve as a basis for
averaging.
Suffix:
<n>
.
irrelevant
Remote Control – Commands