Rohde & Schwarz R&S SMB100B - Page 170

Improving level performance
R&S
®
SMB100B
170User Manual 1178.3711.02 ─ 08
Any R&S NRP sensor that supports the USB legacy protocol and is connected to one
of the USB interfaces, is detected automatically and added to the list. Vice versa, the
R&S SMB100B removes a sensor from the list, when it is disconnected.
R&S NRP sensors that are connected via LAN or use the USBTMC protocol are not
automatically detected. They are detected by the scan search function.
Access:
► Select "Power Sens" > "NRP Sensor Mapping".
The dialog lists all detected R&S NRP sensors for selection and mapping. You can
also browse the network for sensors.
The detected sensors are characterized by the used protocol and the correspond-
ing connector icon. In the "Mapping" column, you can assign the sensor to one of
the available sensor channels. The list can contain several entries but the
R&S SMB100B can only use up to four sensors simultaneously.
The remote commands required to define these settings are described in Chap-
ter 12.14, "SENSe, READ, INITiate and SLISt subsystems", on page 396.
Settings
Sensor Mapping List................................................................................................... 171
Scan............................................................................................................................171
Clear............................................................................................................................171
Add Sensor/Hide 'Add Sensor'....................................................................................171
Add Sensor settings....................................................................................................171
└ Add LAN Sensor settings..............................................................................171
└ Add USB Sensor settings............................................................................. 171
Using power sensors