Improving level performance
R&S
®
SMB100B
171User Manual 1178.3711.02 ─ 08
Sensor Mapping List
Shows the sensors that are connected to the R&S SMB100B.
The table informs on the sensor type, specific features and the installed sensor firm-
ware. It also shows the interface the sensor is connected to, including the communica-
tion protocol and the assigned channel.
Remote command:
:SLISt[:LIST]? on page 400
:SLISt:ELEMent<ch>:MAPPing on page 402
:SLISt:SENSor:MAP on page 402
Scan
Scans the network and the USB connections for sensors connected using the VISA
communication protocol, i.e. sensors that are addressed over LAN or USBTMC.
The instrument detects sensors communicating over the USB legacy protocol automat-
ically.
Remote command:
:SLISt:SCAN[:STATe] on page 400
Clear
Removes the selected sensor from the sensor mapping list.
Remote command:
:SLISt:CLEar:LAN on page 401
:SLISt:CLEar:USB on page 401
:SLISt:CLEar[:ALL] on page 402
Add Sensor/Hide 'Add Sensor'
Shows or hides the "Add Sensor" settings.
Add Sensor settings
Configures settings to add sensors connected to the R&S SMB100B via USB or LAN.
Add LAN Sensor settings ← Add Sensor settings
Configures settings to add sensors connected to the R&S SMB100B via LAN.
"IP Address or Host Name"
Displays the host name or the IP address of a R&S NRP power sen-
sor.
If the R&S SMB100B does not detect a connected R&S NRP sensor,
you can assign the address information manually.
"Add LAN Sensor"
Adds a detected R&S NRP sensor connected in the LAN to the list of
sensors, including its device ID or name and its serial number.
Remote command:
:SLISt:SCAN:LSENsor on page 400
Add USB Sensor settings ← Add Sensor settings
Configures settings to add sensors connected to the R&S SMB100B via USB.
Using power sensors
To Next Page
Loading...
