Rohde & Schwarz R&S SMB100B - Page 400

Remote control commands
R&S
®
SMB100B
400User Manual 1178.3711.02 ─ 08
:SENSe<ch>[:POWer]:FILTer:LENGth[:USER].................................................................. 406
:SENSe<ch>[:POWer]:FILTer:NSRatio............................................................................. 407
:SENSe<ch>[:POWer]:FILTer:NSRatio:MTIMe.................................................................. 407
:SENSe<ch>[:POWer]:FILTer:SONCe.............................................................................. 407
:SENSe<ch>[:POWer]:FILTer:TYPE.................................................................................408
:SENSe<ch>[:POWer]:FREQuency..................................................................................408
:SENSe<ch>[:POWer]:LOGGing:STATe............................................................................409
:SENSe<ch>[:POWer]:OFFSet........................................................................................409
:SENSe<ch>[:POWer]:OFFSet:STATe..............................................................................409
:SENSe<ch>[:POWer]:SNUMber?................................................................................... 409
:SENSe<ch>[:POWer]:SOURce.......................................................................................410
:SENSe<ch>[:POWer]:STATus[:DEVice]?......................................................................... 410
:SENSe<ch>[:POWer]:SVERsion?...................................................................................410
:SENSe<ch>[:POWer]:TYPE?......................................................................................... 411
:SENSe<ch>[:POWer]:ZERO...........................................................................................411
:SLISt[:LIST]?
Returns a list of all detected sensors in a comma-separated string.
Return values:
<SensorList> String of comma-separated entries
Each entry contains information on the sensor type, serial num-
ber and interface.
The order of the entries does not correspond to the order the
sensors are displayed in the "NRP Sensor Mapping" dialog.
Example: See Example"Detecting and assigning a power sensor"
on page 398.
Usage: Query only
Manual operation: See "Sensor Mapping List" on page 171
:SLISt:SCAN[:STATe] <State>
Starts the search for R&S NRP power sensors, connected in the LAN or via the
USBTMC protocol.
Parameters:
<State> 1 | ON | 0 | OFF
*RST: 0
Example: See Example"Detecting and assigning a power sensor"
on page 398.
Manual operation: See "Scan" on page 171
:SLISt:SCAN:LSENsor <IP>
Scans for R&S NRP power sensors connected in the LAN.
SENSe, READ, INITiate and SLISt subsystems