Rohde & Schwarz R&S SMB100B - Page 379

Remote control commands
R&S
®
SMB100B
379User Manual 1178.3711.02 ─ 08
Prerequisites for this command:
●
Select an SNMP version that supports communities (SYSTem:COMMunicate:
SNMP:VERSion on page 381).
Setting parameters:
<CommunityString> String containing the community name.
Example: //Set community name
SYST:COMM:SNMP:VERS V12
SYST:COMM:SNMP:COMM:RO 'ABC'
Usage: Setting only
Manual operation: See "Access" on page 300
SYSTem:COMMunicate:SNMP:COMMunity:RW <CommunityString>
Defines the SNMP community string for read-write access.
Prerequisites for this command:
●
Select an SNMP version that supports communities (SYSTem:COMMunicate:
SNMP:VERSion on page 381).
Setting parameters:
<CommunityString> String containing the community name.
Example: //Set read-write access
SYST:COMM:SNMP:VERS V12
SYST:COMM:SNMP:COMM:RW 'ABC'
Usage: Setting only
Manual operation: See "Access" on page 300
SYSTem:COMMunicate:SNMP:CONTact <SnmpContact>
Defines the SNMP contact information for the administrator.
You can also set the contact information via SNMP if you do not set it via SCPI.
Parameters for setting and query:
<SnmpContact> String containing SNMP contact.
*RST: "" (empty string)
Example: //Set SNMP contact
SYST:COMM:SNMP:CONT 'ABC'
Manual operation: See "Contact" on page 300
SYSTem:COMMunicate:SNMP:LOCation <SnmpLocation>
Defines the SNMP location information for the administrator.
You can also set the location information via SNMP if you do not set it via SCPI.
HUMS remote control commands