Rohde & Schwarz R&S SMB100B - Page 380

Remote control commands
R&S
®
SMB100B
380User Manual 1178.3711.02 ─ 08
Parameters for setting and query:
<SnmpLocation> String containing SNMP location.
*RST: "" (empty string)
Example: //Return SNMP location
SYST:COMM:SNMP:LOC?
Manual operation: See "Location" on page 300
SYSTem:COMMunicate:SNMP:USM:USER <Name>, <Access>, <Level>[,
<Auth_pwd>[, <Priv_pwd>]]
Defines an SNMP user profile.
Prerequisites for this command:
●
Select SNMPv3 (SYSTem:COMMunicate:SNMP:VERSion on page 381).
Setting parameters:
<Name> String containing name of the user.
<Access> RO | RW
Defines the access right a user can have.
<Level> NOAuth | AUTH | PRIVacy
Defines the security level.
<Auth_pwd> String containing the authentication password.
<Priv_pwd> String containing the privacy password.
Example: //Create user profile
SYST:COMM:SNMP:VERS V123
SYST:COMM:SNMP:USM:USER 'Peter','RO','PRIV',
'1234','XYZ'
Usage: Setting only
Manual operation: See "Add SNMP User for HUMS" on page 303
SYSTem:COMMunicate:SNMP:USM:USER:ALL?
Queries the number of users and a list of all SNMP users for SNMPv3.
Prerequisites for this command:
●
Select SNMPv3 (SYSTem:COMMunicate:SNMP:VERSion on page 381).
Return values:
<Count> Total number of registered SNMP users.
<Name> List of all user names as a comma-separated list.
Example: //Return all SNMP users
SYST:COMM:SNMP:USM:USER:ALL?
Usage: Query only
HUMS remote control commands