Rohde & Schwarz R&S SMB100B - Page 536

Remote control commands
R&S
®
SMB100B
536User Manual 1178.3711.02 ─ 08
Parameters:
<UpdatePolicy> STRict | CONFirm | IGNore
*RST: n.a. (factory preset: CONFirm)
Setting parameters:
<SecPassWord> string
Manual operation: See "Secure Update Policy" on page 251
:SYSTem:SPECification? <Id>
Retrieves data sheet information for a specific parameter.
Setting parameters:
<Id> string
Identifies the name of the entry in the data sheet, as queried
with the command :SYSTem:SPECification:
IDENtification:CATalog? on page 536
Return values:
<ValList> float
Comma-separated list with the specified and, if available, the
typical value of the parameter, as specified in the data sheet.
See also Chapter 11.6.2.3, "Datasheet", on page 314.
Example: See Example"Retrieving instrument specification" on page 517.
Usage: Query only
:SYSTem:SPECification:VERSion <Version>
Selects a data sheet version from the data sheets saved on the instrument.
Further queries regarding the data sheet parameters (<Id>) and their values refer to
the selected data sheet.
To query the list of data sheet versions, use the command :SYSTem:
SPECification:VERSion:CATalog? on page 537.
Parameters:
<Version> string
Example: See :SYSTem:SPECification? on page 536.
:SYSTem:SPECification:IDENtification:CATalog?
Queries the parameter identifiers (<Id>) available in the data sheet.
Return values:
<IdList> string
Comma-separated string of the parameter identifiers (<Id>)
Example: See :SYSTem:SPECification? on page 536.
SYSTem subsystem