Rohde & Schwarz R&S SMB100B - Page 67

RF signal configuration
R&S
®
SMB100B
67User Manual 1178.3711.02 ─ 08
In the "Phase" tab, you can determine the delta phase value and reset the phase to
this reference.
2. Switch to the home screen, "Frequency" tile.
The R&S SMB100B indicates the configured settings.
The remote commands required to define the settings are described in Chap-
ter 12.15.9, "SOURce:PHASe subsystem", on page 491.
Settings
Delta Phase...................................................................................................................67
Reset Delta Phase Display........................................................................................... 67
Delta Phase
Sets the phase of the RF signal.
The current phase of the signal is used as the reference.
Remote command:
[:SOURce<hw>]:PHASe on page 491
Reset Delta Phase Display
Adopts the selected "Delta Phase" value as the current value, and resets delta phase
to 0 degrees.
Remote command:
[:SOURce<hw>]:PHASe:REFerence on page 491
RF phase settings